The fuel filter should be changed to accordance with instructions for care, but it should be exempt from the condensate, if it is detected by a warning light signaling. The filter is located in the engine compartment. To drain the condensed water to the screws on the underside of the filter housing and include a hand pump until the water is not spilled at least 100sm3 fuel then again to close the bolt if fuel does not flow, it is necessary to remove the drain from the hydraulic fuel pump that air can get into the filter. To replace the filter to remove both the hose after the designation of the connections. Detach the plug from the bottom of the filter (the water content of the pointer) and unscrew the pointer. With filter key which is used for the oil filter, unscrew the filter element at the bottom of the 'O-ring O''-wet with diesel fuel filter element and screw the cap on the filter. Screw Index water level and leave the plug.
Now you need to remove air from the fuel system as follows: Open vent on the fuel filter and activate the hand pump until the start out of the holes threaded plugs only fuel-free air. Fully squeeze the pistons pump and tighten the screw plug. Newly actuated hand pump "if the pump pistons move with effort. This will be subjected to pressure piping between the filter and fuel pump Water level indicator can be monitored with an ohmmeter. .